Données clés
Unité d'insertion des bâtons dégroupés (emballés dans des cartons en vrac) dans les crèmes glacées extrudées
Capacité :
Plus de 200 bâtons/minute par unité
Applications :
Des bâtons droits ou en forme de pale (dans les crèmes glacées ou les sorbets extrudés)
Highest capacity with gentle handling
- Highly reliable, high performance unit, with 100+ machines in operation worldwide
- Gentle handling of sticks even at high speeds, minimizes waste
- Hygienic operation as sticks are automatically transferred from the hopper to the magazine
Caractéristiques
High capacity stacker (single)
Enables high speed operation
The high capacity stacker takes the sticks from the boxes and neatly organizes them into the vertical feeding stack. This makes it possible to insert over 200 sticks per minute, per lane
Inserter mechanism
Enhances production reliability and yield
The slide pusher drive mechanism has an open design to prevent dust from building up and so secure the highest possible availability and yield.
User-friendly operator panel (single)
Enables product repeatability
Pre-set recipes for each product are stored in the control system, so operating staff just have to press a single button at start-up. The system continuously monitors stacking and dispensing operations, and sounds the alarm if – for example – a stick is missing. The operator can then immediately address the problem, or the system will pull this lane out of operation.
Options
Stick inserter
For gentle handling during stick insertion
A pneumatic drive is standard in this unit, but it can also be delivered with a patented servo controlled stick inserter drive. This enables full control over insertion speeds and forces, even at high speeds. It also consumes less power and prevents sticks from getting damaged.
Feeding arch and dispensing magazine
Enables varied stick sizes
The standard feeding arch and dispensing magazine can be switched to an optional one equipped to handle sticks of a different length or width.
Modular design
Enables different layout options
Two modules can be placed close together, without hindering operator access. For example, the magazines can be placed to the left or right in relation to the extrusion station – or even placed behind a wall outside the wet zone.
